× J-n-C Project Cars

Project Moff - 600 BHP R33 GTS-t Race Car

More
11 years 1 week ago #35171 by moff
Hiya All,

Sorry for a delay in updating....

The car is now back with Abbey Motorsport for a little bit of work.

Dyno Run - Bit of a health check to make sure car is performing ok
Suspension alignment - Abbey have a new hunter 4 wheel alignment and geometry set up tool which was recently installed.
Service - Change all the fluids....

Few other bits... :)

Keep you posted...

Please Log in to join the conversation.

More
10 years 11 months ago #35174 by moff
This Sunday we are set to go to Silverstone F1 Circuit for the day, weather looks like there is a chance of rain, but fingers crossed...

The Go Pro is charged, so lots of video and photos to come... :)

Please Log in to join the conversation.

More
10 years 11 months ago #35175 by moff
Here is the Dyno run from Abbey Motorsport the other day.

BHP figure is on the right middle (618 at the hubs)

Lb/ft is on the left middle (divided by Diff Ratio which is 4.111:1, giving about 475 lb/ft)

Its maxing out the injectors, so has been set back a little form this run



Weather is looking like it might be dry, I can't wait for this Sunday !!!

Please Log in to join the conversation.

More
10 years 11 months ago #35176 by Mr. G
B) Sounds awesome...........Be nice to see it in action some time

JDM Isuzu Vehi-Cross....3.2l Quad Cam V6.....(Judge Dredd's Daily)
JDM Isuzu TFS 69 Crew Cab 3.1l Turbo.....(Work Horse)
UK Toyota Rav 4 (Shopping Trolley)

Non Jap....VX 220 Turbo Stage 2


Former Glories.....S14 200sx,R33 GTR......

Please Log in to join the conversation.

More
10 years 11 months ago #35179 by moff
We had a cracking day out at Silverstone on Sunday 9th March with Abbey Motorsport
and their crew. Quite a few Abbey customers too. The weather was fantastic.

Photos and videos to come...

Please Log in to join the conversation.

More
10 years 10 months ago #35180 by moff
Hiya All,

I've done a little write up of the work carried out at Abbey Motorsport.

Couple of videos of the car on the Dyno too... :)



www.theprojectmoff.co.uk/2-march-2014---...ct_moff_2_march_2014

Please Log in to join the conversation.

More
10 years 10 months ago #35245 by moff
During one of the laps on the recent track day, I snapped a tie rod. Was pretty scary in the car, sounded much noisier than on the video !!!


Please Log in to join the conversation.

More
10 years 10 months ago #35247 by 3gdean
Ooooo nasty!!!

definately an arse twitch moment.

sorry havent read the build thread yet,,, are you using aftermarket tie rods, seen a few cars with rose joints. Meant to be good.

Please Log in to join the conversation.

More
10 years 10 months ago #35262 by moff
Sory for the delay, here is a write up, with in car video laps, and lot sof photos of hte day.

Huge Thank you to Abbey Motorsport for the work on the car again :)



In car lap

.
.
Full write up here... www.theprojectmoff.co.uk/09-march-2014--...mpaign=09_march_2014
.
.
.
The following user(s) said Thank You: gtir350

Please Log in to join the conversation.

More
10 years 9 months ago #35290 by gtir350

Please Log in to join the conversation.

Time to create page: 0.105 seconds
Powered by Kunena Forum